View Full Version : Two-Faced Jack 'O Lantern
12-02-2009, 10:49 PM
Can't believe it!!! I've never seen it before.... so have you?
I wish I would carve like that..... but I only did carve a large 22 pounds pumpkin with 2 faces (front and back) only.
12-04-2009, 09:07 AM
I have a really old Pumpkin mask (it's huge!) with numerous faces on it, very aukward to try to actually wear for too long, but it looks very nifty!
Of course if it were a real pumpkin it would not even be lift-able!
12-04-2009, 04:00 PM
I'm getting a "page not found" message when I try to view the phot. Is that the right link?
Here's a link to cool item for making pumpkins. They are selling pumpkin plastic teeth for pretty cheap. It seems like a good decorating idea (and pretty cool site). And no, I'm not affiliated with them in any way.
12-04-2009, 05:06 PM
Thanks for that link monster, I can use those teeth for other monster applications.
12-04-2009, 06:00 PM
So I pushed modeling clay over my upper teeth, pulled them out, poured liquid latex in, peeled off the clay when dry, did this about four times, then latex/glued the teeth all together to fill a really big mouth, I put a little bit of "Me" in that costume, anybody else operate like this? Sure you do, fess up!
"Look at those scary teeth!"
I just grin....
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.