View Full Version : Flexible sprayfoams as Smooth-on...etc
10-15-2012, 03:26 PM
I didn't see a whole lot of info on the forum regarding flexible foam fills for molds/sculptures..(including spray-on ..etc) such as the foam Ed uses as Distortions. This is probably aimed toward vendors, but, I just wanted to start a dicussion on experiences, resources, most affordable websites for purchasing...
10-15-2012, 06:59 PM
there really is not a flexible spray foam, they just never show him mixing it. It is an A/B mix. Foam is referred to by its density, foam that weighs 3lbs in a 1ft x 1ft cube is called 3lb foam. there is 5lb, 8lb, and 10lb foam. I have seen 1lb and 20lb foam but they are rare.
smooth-on is a good source as well as www.bitymoldsupply.com
10-15-2012, 08:45 PM
I'm wondering what they are painting the clay with on the Making Monsters program. It is sometimes red, brown or orange. A very nice surface on water based clay.
10-15-2012, 09:05 PM
It is just spraypaint Greg, just a barrier between the clay and plaster. any kind but enamel.
10-15-2012, 11:12 PM
I'm building a few props and need to animate them, so flexibility and durability is ut-most important. Thanks for website reference Allen, seems pretty good variety. Maybe Kevin over at GG, might have some recommendations... I know these foams absorb moister a bit, so, curious as to difference of mixing for indoor/outdoor usage...etc
10-16-2012, 06:27 AM
It is best if the foam doesn't have to flex. cover the joints with another material.
And if you are using the foam outside you need to SEAL the foam. Most foams are open cell even if they are self skinning. They will absorb water.
10-16-2012, 11:33 AM
If your making foam filled props for outdoors I would not recommend using any open-cell foam. Open-cell foam is what cheap sponges are made of so even if you seal it any crack tear or missed spot will suck up water and in time ruin your prop.
Like Kevin said use something else for joints. Most of the time Distortions sprays in a latex coating first then applies the foam for filler. Kevin also mentions self skinning foams which are ones that don't require a latex base and make a pretty nice outside skin. Those come in both rigid and flex foam.
If your looking for cheap foam, let me know when you find it cause I've never seen any foam that is cheap. Have to admit, I've never looked too hard since I keep my products small on purpose.
Foam that is used to fill boat cavities is always closed foam so you might want to look for foam at those types of sites.
Lastly, when working with any of this kind of stuff, don't forget the respirator, glasses & gloves. Do as I say not as I do. haha
Good luck and let us know how it turns out!
Powered by vBulletin® Version 4.2.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.